350ml Flow Restrictor Spiral Kit
350 ML Flow Restrictor Spiral Kit, 1/4 IN orange tubing and 1/4 IN unions for use with 35 GPD membrane
This flow restrictor 350 ML spiral kit is for use with 35 GPD membrane. It has 1/4 IN orange tubing and 1/4 IN unions.
- Flow Restrictor Spiral Kit 350 ML
- Used with the 35 GPD membrane
- 350 ML orange spiral insert
- 1/4 IN red tube with 1/4 IN union connector
NEW FLOW RESTRICTOR INSTALLATION:
- Remove the black tube at the end of the membrane housing (see diagram below)
- Remove the existing flow restrictor
- Install new flow restrictor as follows:
Please review this guide to learn how to remove the existing flow restrictor and add the new one.
- Turn water off to system at Adapt-A-Valve & drain tank by leaving RO faucet open.
- Remove existing flow restrictor by un-screwing it and cut it as shown in the diagram below:
- Disconnect red tube at port labeled DRAIN; then install the new Flow restrictor tube into that port & connect red tube from faucet to supplied connector as shown below: